Is there any way I could get similar dimension batteries (see Chinese-built board photos) that are denser and give more power? The 5 mile range that is rated for these batteries is pretty terrible, and if I need to lengthen the enclosure somehow, I will. This board will read 50% battery, but the voltage would be EXTREMELY low (the torque on the hub motors would be basically nonexistent). I don’t think it has a proper BMS, as it suffers from a common design flaw of having a bad fuel gauge. Would it be possible to use the current system that is in the board?īattery: The batteries currently on the Acton Blink Lite is VERY bad. ELECTRIC SKATEBOARDS ACCESSORIES ACTON FLEET SOLUTION SUPPORT 0. I would probably need a new VESC, but I am not sure. This remote control is good for Blink Lite, BLINK S, and BLINK S2 electric skateboard. Just planning out what I would need to do if I bought this motor though:Īt the very least, I would need new wheels that are larger and match the 83mm hub motor wheels I definitely do not need to reach these speeds on such a small board, and I think 15-18mph would be a good theoretical max to reach. I was thinking of using these hub motors:ĭiy-electric-skateboard-kits-parts/torque-single-hub-motor/ In reality, the board averages at 7mph and never goes past 9mph, which is simply too slow for my commute to college. Has a maximum power of 450W, going “10mph”. The current hub motor according to Acton’s website: But, I think that the board has a few shortcomings that I want to improve on by modding it myself!įirst and most importantly, I want a more powerful motor. I bought an Acton Blink Lite for pretty cheap ($300) on an Ebay sale, and the board has been great so far.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |